Set-Up; Receiving And Inspection; Unpacking; Machine Moving - Baker A User Manual

SET-UP

Receiving and Inspection


Upon receipt and prior to signing transport carrier's documents, conduct a walk-around
and visual inspection of your new equipment. Note any damage in writing upon the
carrier's bill of lading and contact us immediately.
Note: All new equipment is assembled and thoroughly tested prior to shipment, however
damage may occur during transit, which could cause the machine to not operate correctly
during start-up.

Unpacking


If machine was delivered via flatbed trailer, remove straps or chains securing it in place.

If machine was delivered by crate, carefully remove upper crating materials from the base
skid.

Remove lag screws, strapping, etc. that attaches the machine to the skid.

Machine Moving


Lift machine at the indicated lift points only.
o Use a safety strap to avoid tip-over.

Transport machine to the installation site.
Machine Positioning (Placement, Leveling, Alignment)

For optimum performance, designate a solid and level foundation that is covered and dry,
free of environmental elements such as rain or snow that could cause electrical or slip
hazards.

Provide a minimum of 3 feet of clear workspace in front of the electrical panel.

Provide a minimum of 15 feet of clear workspace in front of in-feed and off-load areas.

Power and Utilities Requirements


For safe and effective operation confirm your incoming voltage and available
amperage is equal to what the machine has been wired for at the factory.
 A qualified electrician should complete electrical connections and check
for correct motor directional rotation.

Ensure all wiring and electrical connections are located in a safe position and away
from any hazardous conditions.

Efficient dust and chip removal requires a minimum of 600 CFM suction at the
machine dust removal chute. This is an employer/owner responsibility.

14