TOHATSU MFS 40A Owner's Manual page 76

76
INSPECTION AND MAINTENANCE
Oil plug specified tightening torque
4N·m (3 ft·lb, 0.4 kgf·m)
ENOW00095-0
Do not reuse oil plug gasket. Always use new
gasket and tighten oil plug properly to pre-
vent entry of water into lower unit.
ENOW00928-0
Wipe off gear oil well immediately if spilled
and dispose of it in accordance with local
fire prevention and environment protection
regulations.
10
ENON00032-0
Note
If water in the oil, giving it a milky colored
appearance. Contact your dealer.
CAUTION
ENOF00101-A
CAUTION
ENOM00086-A
Propeller replacement
ENOW00084-0
WARNING
Do not begin propeller removal and instal-
lation procedure with spark plug caps
attached, shift in forward or reverse,
main switch at other than "OFF", engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnect battery cable if
possible.
The propeller edge is thin and sharp. Wear
the groves during replacement to protect
your hands.
ENOW00086-0
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread the pin
apart to prevent it from falling out which
could lead to the propeller coming off
during operation.
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
1. Put a piece of wood block between
propeller blade and anti-ventilation
plate to hold propeller.