TOHATSU MFS 40A Owner's Manual page 54

54
ENGINE OPERATION
1. Perpendicular to the water surface
ENOM00053-0
Improper trim angle (bow rises too
high)
Set the thrust rod lower if the bow of the
boat rises above horizontal.
7
ENOM00054-0
Improper trim angle (bow dips into the
water)
Set the thrust rod higher if the bow of
the boat is below horizontal.
1
ENOF00051-1
1. Thrust rod
2. Higher
3. Lower
Trim angle adjustment
The transom angle adjustment
1. Stop the engine
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Lock the tilt stopper
5. Remove the snap pin and thrust rod
ENOF00052-0
1. Snap pin
2. Thrust rod
6. Reinstall the thrust rod in the desired
ENOF00053-0
7. Put the snap pin back and unlock the
8. Gentry tilt down the outboard motor.
3 3
1
as shown picture.
1
position securely.
tilt stopper.
2 2
ENOF00888-0
2
ENOF01147-0