TOHATSU MFS 40A Owner's Manual page 35

Remedy
1.
Reduce the throttle to less than half
opening, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
aged blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with new one.
2.
Move to safe place quickly, and stop
the engine.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
3.
Move to safe place quickly, and check
the discharge of cooling water from
the water check port at idle speed
and stop engine.
Remove any foreign matter on the
gear case and propeller if necessary.
Consult an authorized dealer if no
discharge of cooling water.
4.
Charge or replace the battery.
5.
Consult an authorized dealer.
6.
Replace the engine oil (See page 71)
and reset the indicator (See page 35).
ENOW00025-A
CAUTION
Low speed ESG ON: Engine speed will be
limited to 2800 min
should not continue to run engine.
High speed ESG ON: Engine speed will be
limited to 6200 min
run rough until throttle is reduced.
-1
(rpm), however you
-1
(rpm) and engine will
PRE-OPERATING PREPARATIONS
ENOM00870-0
Engine oil replacement indicator
function reset method
As for "Engine oil replacement indicator
function", informing the appropriate
timing of engine oil replacement by blink-
ing of the lamp, when beyond 100 hours
operating.
1. Be certain the safety lanyard is
installed. Turn the key to the 'on'
position and after the 'beep' pull the
safety lanyard off.
2. Within 5-10 seconds, Pull the red
knob on the safety switch out and
release.
35
1 Second
ENOF00853-0
ENOF00854-0
6