BRP Sea-Doo MOVE Series Operator's Manual page 38

MAINTENANCE AND INSPECTION PROCEDURES
7. Install the dust cover. Tap lightly
on the edges to place the dust
cover.
8. Use a screwdriver and a hammer
to tap the dust cover until it is com-
pletely into the hub and the flange
on the dust cover is tight against
the hub face. Alternate sides
around the dust cover to avoid any
bending.
9. Repeat on other wheels.
L L i i g g h h t t s s
All the lights are built with LEDs (light
emitting diode) and this technology
proved to be reliable. In the unlikely
event they do not work, have them
checked by an authorized Sea-Doo
dealer.
W W i i n n c c h h
W W i i n n c c h h I I n n s s p p e e c c t t i i o o n n
Inspect gears, bushings and strap for
wear or damage.
W W i i n n c c h h L L u u b b r r i i c c a a t t i i o o n n
Apply a thin coat of multipurpose
grease to the gearing teeth and pivot
points. Rotate handle to distribute
grease evenly.
Lubricate ratchet pivot point with light
oil.
J J a a c c k k
J J a a c c k k L L u u b b r r i i c c a a t t i i o o n n
Clean grease fitting, then lubricate us-
ing multipurpose grease. Rotate han-
dle to distribute grease evenly.
Lubricate handle pivot point and
wheel axle with light oil. Wipe excess
oil and rotate parts to distribute oil
evenly.
38
1. Grease fitting
W W o o o o d d e e n n B B u u n n k k s s ( ( i i f f E E q q u u i i p p p p e e d d ) )
Check wooden bunks carpet condition
and wood hardness.
R R o o l l l l e e r r B B u u n n k k s s ( ( i i f f E E q q u u i i p p p p e e d d ) )
Check rollers for wear, cracks or
damage.