BRP Sea-Doo MOVE Series Operator's Manual page 21

T T i i g g h h t t e e n n i i n n g g T T o o r r q q u u e e
U-bolts nuts
Winch arm
adjustment
bolt
B B u u n n k k s s
The bunks (wooden or roller type)
must be adjusted according to the
shape of the PWC hull. They must rest
flat on the flat surfaces of the hull.
B B u u n n k k A A n n g g l l e e ( ( M M O O V V E E I I a a n n d d M M O O V V E E I I I I
S S e e r r i i e e s s ) )
To adjust the angle:
1. With the PWC off the trailer, loos-
en the bolts retaining the bunks to
their supports.
2. Load the watercraft on the trailer
and make sure that the bunks rest
flat on a flat part of the hull as
shown.
If the bunks do not rest on a suit-
able part of the hull, refer to appro-
priate Bunk Height and Lateral
Position section.
M M O O V V E E I I - - W W O O O O D D E E N N B B U U N N K K S S H H O O W W N N
1. Bunk square with hull
2. Bolt
27 ± 3 Nm (20
± 2 lbf-ft)
27 ± 3 Nm (20
± 2 lbf-ft)
M M O O V V E E I I I I - - W W O O O O D D E E N N B B U U N N K K S S H H O O W W N N
1. Bunk square with hull
2. Bolt
3. Tighten bolts to specified torque.
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Bunk retaining
bolts
B B u u n n k k H H e e i i g g h h t t a a n n d d L L a a t t e e r r a a l l P P o o s s i i t t i i o o n n
( ( M M O O V V E E I I S S e e r r i i e e s s ) )
W W A A R R N N I I N N G G
A A l l w w a a y y s s s s e e t t b b o o t t h h b b u u n n k k s s t t o o t t h h e e
s s a a m m e e h h e e i i g g h h t t a a n n d d l l a a t t e e r r a a l l s s t t a a n n c c e e . .
To change the height and position:
N N O O T T E E : :
The height can be changed at front of
the bunks only.
1. Remove the PWC from the trailer.
2. If the height has to be changed, re-
move the front support U-bolts.
3. Install the U-bolt in the holes corre-
sponding the desired height, but
do not tighten yet.
TRAILER SET-UP
21 ± 3 Nm (15
± 2 lbf-ft)
21