BRP Sea-Doo MOVE Series Operator's Manual page 29

L L A A U U N N C C H H I I N N G G T T H H E E W W A A T T E E R R C C R R A A F F T T
1. Prepare the watercraft for launch-
ing according to the watercraft
manufacturer's recommendations.
2. Remove tie-downs from stern and
trailer eyelets.
3. Disconnect lights connector.
4. Make sure the way is clear behind
the trailer (in and out of water).
5. Attach ropes to the watercraft
mooring cleats and prevent them
from hanging.
6. Have someone guiding you and
back the
reaches the desired depth into
water.
N N O O T T E E : :
The watercraft must not float above
the bunks.
7. Hold the winch handle firmly and
set winch mechanism to "unwind".
S S E E T T W W I I N N C C H H T T O O " " U U N N W W I I N N D D " "
8. Unwind until watercraft slides off
the trailer and floats. It may be
necessary to push the watercraft a
little.
9. Grab the ropes previously at-
tached to the mooring cleats.
10. Detach the watercraft from the
winch strap.
11. Moor the watercraft.
12. Drive the tow vehicle out of the
ramp.
13. Connect lights connector.
vehicle until trailer
29