BRP Sea-Doo MOVE Series Operator's Manual page 23

T T Y Y P P I I C C A A L L
1. Winch support retaining nuts
2. Mounting plate
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Winch support
retaining nuts
To adjust front to rear winch position,
loosen the six (6) nuts, move forward
or rearward to desired position, then
tighten nuts as per the following table.
T T Y Y P P I I C C A A L L
1. Winch support retaining nuts
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Winch support
retaining nuts
B B o o w w S S t t o o p p p p e e r r R R o o l l l l e e r r
Set bow roller stopper so that it leans
on the PWC bow between rubber
bumper and bow eyelet (or bow cup
on selected models).
34 Nm (25 lbf-ft)
34 Nm (25 lbf-ft)
1. Area where the roller must lean
To adjust:
1. Loosen the four (4) winch adjust-
ment nuts as shown.
2. Set the bow roller stopper to the
desired height, then lock it in posi-
tion by tightening nuts as per the
following table.
T T Y Y P P I I C C A A L L
1. Winch adjustment nuts
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Winch
adjustment
nuts
B B u u n n k k s s
B B u u n n k k A A n n g g l l e e
To adjust the angle:
1. With the PWC off the trailer, loos-
en the bolts retaining the bunk to
its support.
TRAILER SET-UP
34 Nm (25
lbf-ft)
23