BRP Sea-Doo MOVE Series Operator's Manual page 24

TRAILER SET-UP
T T Y Y P P I I C C A A L L
2. Load the watercraft on the trailer
and make sure that the bunks rest
flat on a flat part of the hull as
shown. If the bunks do not rest on
a suitable part of the hull, refer to
BUNK LATERAL
(PAGE 24) BUNK LATERAL PO-
SITION section.
T T Y Y P P I I C C A A L L
1. Bunk resting flat
3. Tighten the bolts to specified
torque.
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Bunk retaining
bolts
B B u u n n k k L L a a t t e e r r a a l l P P o o s s i i t t i i o o n n
W W A A R R N N I I N N G G
A A l l w w a a y y s s s s e e t t b b o o t t h h b b u u n n k k s s t t o o t t h h e e
s s a a m m e e l l a a t t e e r r a a l l s s t t a a n n c c e e . .
To adjust the position:
1. With the PWC off the trailer, loos-
en the nuts on top of the support.
24
POSITION
7 Nm (62
lbf-in)
N N O O T T E E : :
The supports may have a block under-
neath. The procedure is the same.
T T Y Y P P I I C C A A L L
2. Slide the bunk to the desired
position.
T T Y Y P P I I C C A A L L
3. Tighten nuts to specified torque.
4. Adjust the angle if necessary, refer
to Bunk Angle .
T T i i g g h h t t e e n n i i n n g g t t o o r r q q u u e e
Bunk support
nuts
S S p p a a r r k k ™ ™ M M O O V V E E I I I I M M o o d d e e l l s s
This trailer is specifically made to
transport the Spark PWC. No adjust-
ment is required.
N N O O T T I I C C E E
D D o o n n o o t t u u s s e e t t h h i i s s t t r r a a i i l l e e r r t t o o t t r r a a n n s s p p o o r r t t
a a n n y y o o t t h h e e r r m m o o d d e e l l o o f f P P W W C C . . U U s s e e t t h h i i s s
t t r r a a i i l l e e r r o o n n l l y y t t o o t t r r a a n n s s p p o o r r t t t t h h e e S S p p a a r r k k
m m o o d d e e l l s s . .
41 Nm (30
lbf-ft)