PB TEEN Beadboard Daybed & Trundle Assembly Instructions

Table of Contents

Download this manual

Beadboard Daybed & Trundle

•

Please read all instructions before beginning assembly.

•

Two-adult assembly is recommended.

•

Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or

hardware.

A – Headboard Cabinet – 1 pc

D – Rear Panel – 1 pc

G – Adjustable Shelf – 2 pcs

H – Wooden Knob with Bolt – 3 pcs

B – Footboard – 1 pc

E – Slats Roll – 1 pc

I – Wooden Knob – 3 pcs

www.pbteen.com

C – Front Rail – 1 pc

F – Trundle with Slat Roll – 1 pc

J – Wooden Knob Bolt – 3 pcs

(5/32" x 28mm)

Table of Contents

Need help?

Do you have a question about the Beadboard Daybed & Trundle and is the answer not in the manual?

Page 1 Beadboard Daybed & Trundle Pre-assembly: • Please read all instructions before beginning assembly. • Two-adult assembly is recommended. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. Parts Included: A – Headboard Cabinet – 1 pc B –...
Page 2 K – Phillips Head Screw – 28 pcs L – Shelf Support Peg – 8 pcs M – Connecting Metal Plate – 1 pc (#8x30) N – Phillips Head Screw – 4 pcs (#6x15) Tools Required: Phillips Head Screwdriver (not included) Assembly Instructions: 1.
Page 3 4. Lay the Slat Roll (E) down onto the inner ledges of the Front Rail (C) and Rear Panel (D). Using a Phillips Head Screwdriver, loosely fasten the Slat Roll (E) to the rails with the Phillips Head Screws (K), as shown below.
Page 4 Beadboard Daybed Desk Pre-assembly: • Please read all instructions before beginning assembly. • Two-adult assembly is recommended. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. Parts Included: A – Desk Pedestal – 1 pc B –...
Page 5 Tools Required: Phillips Head Screwdriver (not included) Instruction 9. Place the Pedestal (A) in the desired position and gently attach Wooden Knobs (D) to drawer and door fronts by holding the Wooden Knob (D) over the pre-drilled holes in drawer and door front. Screw a Wooden Knob Bolt (E) through the rear of the drawer and door so that it enters the Wooden Knob (D).