PB TEEN Brass Trim Shaped Mirror Mounting Instructions

This Brass Trim Shaped Mirror includes
one hole through which provided mounted
hardware passes for wall-mounting.

Hardware Included:

Tools Needed:

1) Hold the item upright and level against a wall at a desired mounting location. Use a
level to ensure that the item is level and then use a pencil to mark the wall through
one mounting hole. Set the item aside.
2) The provided anchor cannot penetrate wood studs. Therefore we have to
determine if any of the three Marks of Step (1) happen to align with a wall stud. Use
a stud-finder to determine this. If any mark does Align with a stud; use a
screwdriver to secure a provided Screw into the wall at this mark when instructed
to do so below.
3) For marks that do not align with a wall stud, use a screwdriver to install a provided
anchor into the wall at the mark.
screwdriver and position the anchor's tip at the mark. Rotate the anchor clockwise
while pushing it firmly into the wall. The anchor will automatically drive itself into
the wall. Continue rotating until the wide end of the anchor becomes even with the
wall surface. Do not over-tighten.
4) return the Brass Trim Shaped Mirror to the wall so that the one hole aligns with
either a stud or an installed anchor. Use a screwdriver to secure a screw through
one hole and into the installed anchor or stud. Rotate the screws clockwise until
tight.

Care Instructions:

Wipe with a soft, dry cloth. Do not use any abrasive or chemical household
cleaners.
Brass Trim Shaped Mirror
Mounting Instructions
(1) Anchor, (1) Screw
Phillips Screwdriver, Pencil, Stud-Finder, Level
Thank you for your purchase!
The hardware included with this item is
meant for drywall mounting only. If your wall
is made from another material such as
concrete or plaster, please consult your local
hardware store for assistance in selecting
the correct hardware.
Engage the head of the anchor with the