PB TEEN Beadboard Dresser Topper Quick Start Manual

Advertisement

Beadboard Dresser Topper
—Base & Mirror

Pre-assembly:

Please read all instructions before beginning assembly.
Two-adult assembly is recommended.
Save all packing materials until assembly
is complete to avoid accidentally discarding
smaller parts or hardware.

Parts included:

A – Topper Mirror – 1 pc

Hardware Included:

D – Wooden Knob – 3 pcs
G– Long Phillip Screw – 3 pcs
(#8x45mm)
(for hanging Topper Mirror
on wall only)
J – Anchor – 3 pcs
(for hanging Topper Mirror
on wall only)
Tools Required: Phillip Head Screwdriver (not included)

Assembly:

1. On a soft, scratch-free surface, such as a carpet or rug, remove all the parts from boxes.
2. Determine the desired location of the piece and prepare all parts there first. Note: The Topper Mirror
(A) can be either mounted on the wall or attached to the Topper Base (B). Please refer to the
separate instructions for wall mounting.
3. Attach the Wooden Knobs (D) to the drawer by holding the Wooden Knob (D) over the pre-drilled hole
in the drawer front. Insert a Knob Bolt (F) from the interior of the drawer into the Wooden Knob (D)
and tighten with a Phillips Head Screwdriver. Repeat with other drawers.
B – Topper Base – 1 pc
E – Allen Key – 1 pc
H – Short Phillip Screw – 8 pcs
(#7x20mm)
www.pbteen.com
C – Mirror Support – 1 pc
(for hanging Topper Mirror
on wall only)
F – Knob Bolt – 3 pcs
(M4x32mm)
I – Mending Plate – 2 pcs
(70x40mm)
1/2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Beadboard Dresser Topper and is the answer not in the manual?

Questions and answers

Summary of Contents for PB TEEN Beadboard Dresser Topper

  • Page 1 Beadboard Dresser Topper —Base & Mirror Pre-assembly: • Please read all instructions before beginning assembly. • Two-adult assembly is recommended. • Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware. Parts included: A – Topper Mirror – 1 pc B –...
  • Page 2 4. Remove the Hex Bolts from each support rail on the back of the Topper Mirror (A) by using the Allen Key (E). See illustration. Please keep these Hex Bolts for use in the next assembly step. 5. Assemble the Topper Mirror (A) to the Topper Base (B) by using the support rails that were just removed in Step 4.

Table of Contents