Aftertreatment - PREVOST X3-45 Commuter 2020 Operating Manual

5-24 Other Features

AFTERTREATMENT

This menu permits to the driver to initiate a stationary regeneration, to check the status of the aftertreatment
system and to interrupt regeneration.
DOB 1300-1556
4. Reset Trip Data
This menu can only be accessed if the correct password has been entered.
Use this function to reset measurements of the Trip Data menu before each
new trip or leg.
1. Request Parked REGEN
Use this function to initiate a stationary (parked) regeneration.
Even if parked regeneration is inhibited through the use of geofencing, a
regeneration can nevertheless be initiated. To override IVN regeneration
inhibit function and allow parked regeneration, flip the dashboard RETARDER
switch 4 times (4 transitions from OFF to ON) within 2 seconds. Setting the
ignition switch to OFF will cancel and return to normal geofencing operation.
2. ATS Status
The Aftertreatment status sub-menus provide information about the conditions
required for performing regeneration. The status can be OK (regeneration
allowed), CHECK (regeneration not allowed) or N/A (not applicable). When
ATS Status is selected, the following displays (images at left) will show.
PA-1639 Operator's Manual 2020 X3-45 Commuter