How To Use - Panasonic MX-EX1011 Operating Instructions Manual

Blender
1
Place the ingredients into blender jug, and then close the lid.
Pour li uid first, followed
(i Li uid (ii Soft ingredients (iii Hard ingredients (iv Ice cu es
2
Attach blender jug to the motor housing.
Align the on the motor
housing with the on the
lender ug.
Twist lender ug clockwise
until ou hear a click sound.
Blender ug onl can e attached
a ove steps.
3
Plug in. Hold the blender jug, and then turn the rotary
switch to 1 position to start.
If the appliance stops
during operation. (P. EN8
4
hen lending is completed, turn the rotary switch to
0 position to switch off. Unplug.
Turn the blender jug
anticlockwise to remove it,
open the lid and take out
the ingredients.
How to use the scraper
It can e inserted through the lid opening while lending without
interfering with the lender lade.
Slide the scraper through the lid opening and scrape to remove food sticking to lender ug sides.
To avoid ingredients splattering, it is recommended to insert the scraper from the lid opening
when using lender ug.
Scraper is useful when
too little li uid makes ingredients hard to lend. (e.g. for dips, sauces, curr dishes
ingredients stick to the inner side of container. (e.g. garlic, chile pepper
EN6

How to Use

soft ingredients and then others.
1
2
3
3
4
1
2
Dry mill
To disassemble
Turn anticlockwise
2
1
1
Turn the mill container upside down and place the
ingredients in it. Twist the mill container base
2
clockwise until you hear a click sound.
2
Attach the mill container to the motor housing.
Align the on the motor
housing with the
container.
Twist mill container clockwise
until ou hear a click sound.
Mill container onl can e attached
a ove steps.
1
3
Plug in. Hold the mill container, and then turn the rotary
switch to 1 position to start.
If the appliance stops during
operation. (P. EN8
4
hen lending is completed, turn the rotary switch to
0 position to switch off.
Unplug.
Turn the mill container
anticlockwise to remove it,
open the mill container, and
take out the ingredients.
To assemble
Turn clockwise
Make sure the mill
gasket is not damaged
and placed properl
1
efore assem le.
on the mill
1
3
4
3
1
2
2
2
1
2