Henny Penny LOV LVE-200 Series Quick Start Manual

1. Put on protective gear: Use all McDonald's approved safety equipment including, Apron, Face Shield and
Gloves. Hot oil can cause severe burns.
2. Press and hold
3. Press and release
Press √ √ √ √ √ button and display shows MAN FL TR and YES NO.
4. Press √ √ √ √ √ and display shows DRAINING and the oil drains from the vat,
or press X button for NO and controls return to normal operation. Gas
units, continue to step 6.
5. Electric units only. Use the lift tool and lift the hinged element to clean
the bottom of the vat. Use care not to damage high limit bulb. Figure 1.
6. Use the scouring tool, a nylon scouring pad, and a small amount of McD
Fryer Cleanser to scrub the inside of the vat. Be careful not to damage
the sensing probes.
7. Once vat is clean, the display shows SCRUB VAT COMPLETE?, and
YES NO. Press √ √ √ √ √ and the display shows WASH VAT?, and YES NO.
8. Lower the elements (electric units only) and press √ √ √ √ √ and display shows WASHING (oil is pumped through
the open drain to help wash crumbs out of the vat). Once the wash cycle is complete, display shows WASH
AGAIN?, and YES NO.
9. Press √ √ √ √ √ if another wash is needed, otherwise press X button for NO and the display shows RINSING (vat is
filled with oil and drained to help rinse crumbs off the vat sides). When rinsing is complete, display shows
RINSE AGAIN?, and YES NO.
10. Press √ √ √ √ √ if another rinse is needed, otherwise press X button for NO. Display shows POLISH, and YES.
11. Press √ √ √ √ √ button and the oil is "polished" and the display shows 5:00, followed by STOP POLISH. (Polishing is
filtering the oil for an extended period to clean it.) If desired, press X button for STOP to stop the polishing
early, otherwise the oil is polished for 5 minutes.
12. The display shows FILL VAT?, and YES. Press √ √ √ √ √ and display shows FILLING and vat fills with oil.
13. Once full, display shows IS POT FILLED?, and YES NO. Press √ √ √ √ √ and fryer returns to normal operation.
The filter pad or paper must be replaced daily!
For U.S. Stores:
Any problems, refer to manual or contact Henny Penny Corp. 1-800-417-8405, or 937-456-8405.
These instructions are meant to be guidelines, not complete operating instructions. Read and
understand the complete operator's manual supplied with each unit.
11-30-10
MAINTENANCE FILTER
(End of Day Manual Filter)
(on either side) until display shows 1.AUT O FILTER.
and display shows 2.MAINT FILTER.
Use Magnesol Filter Pad Kit WRIN #03190-054 or
Filter Paper/Powder Filter Kit WRIN #4351-009
Figure 1
FM07-867-A