Operation - Kero-Sun Laser Clean LC-34 Instruction Manual

CAUTION : Always make sure that there is sufficient ventilation.
CAUTION : Always make sure that there is sufficient ventilation.
SET CLOCK
SET CLOCK
It is only possible to set the correct time, when the heater is
connected to the mains and not burning.
It is only possible to set the correct time, when the heater is
1. Use the Adjustment Keys ( ▼ hour / ▲ min.) to set the time.
connected to the mains and not burning.
1. Use the Adjustment Keys ( ▼ hour / ▲ min.) to set the time.
2. To set the time, press "hour" and "min." set
buttons. Individual motions will increase the keys. Individual motions will increase the
time by one unit; holding continuously will
2. To set the time, press "hour" and "min." set
raise either the "hour" or "min." rapidly. After
buttons. Individual motions will increase the
approximately 10 seconds the blinking will
time by one unit; holding continuously will
stop and the setting will be locked. 5 Minutes
raise either the "hour" or "min." rapidly. After
after switching off the heater, the information
approximately 10 seconds the blinking will
on the display will disappear and the heater will automatically switch into the stand-by
stop and the setting will be locked. 5 Minutes
position.
after switching off the heater, the information
on the display will disappear and the heater will automatically switch into the stand-by
position.
IGNITION
IGNITION
1. Just press the
that the ignition procedure has started. This will take a short while.
1. Just press the
2. After this time heater will automatically ignite and The button will cease its flashing. The
that the ignition procedure has started. This will take a short while.
Operation Lamp will remain alight so long as heater is burning.
2. After this time heater will automatically ignite and The button will cease its flashing. The
After this time heater will automatically ignite and ON/OFF Lamp will cease its flashing. The
NOTE : If using your heater for the first time, or after long term storage, ignition may not
Operation Lamp will remain alight so long as heater is burning.
ON/OFF Lamp will remain alight so long as heater is burning.
take place on the first try. Press the
NOTE : If using your heater for the first time, or after long term storage, ignition may not
NOTE : Fuel pump may produce an audible operating noise at ignition. This is only
take place on the first try. Press the
temporary.
NOTE : Fuel pump may produce an audible operating noise at ignition. This is only
temporary.

OPERATION

OPERATION
button to ignite the heater. The
key to ignite the heater. ON/OFF Lamp will start blinking, indicating button to ignite the heater. The
1
1
button will start blinking, indicating
button will start blinking, indicating
button again.
key again. button again.
5
7
5
2
2