Kero-Sun Laser Clean LC-34 Instruction Manual page 8

TIMER IGNITION
TIMER IGNITION
Your heater can be arranged to ignite automatcally at a chosen time by use of a pre-set
"Timer". This "Timer" can only be set after the clock setting has been completed.
Your heater can be arranged to ignite automatcally at a chosen time by use of a pre-set
"Timer". This "Timer" can only be set after the clock setting has been completed.
1. Press the
that. The Timer Lamp and Digital Indicator will start blinking.
1. Press the
that. The Timer Lamp will start blinking. that. The Timer Lamp and Digital Indicator will start blinking.
2. To set the "Timer" to the chosen igntion time, you should follow
the same procedure as given earlier for "Clock" time setting.
2. To set the "Timer" to the chosen igntion time, you should follow
After approximately 10 seconds, the digital indicator will return to
the same procedure as given earlier for "Clock" time setting.
"Clock" mode, displaying the present time.
After approximately 10 seconds, the digital indicator will return to
"Clock" mode, displaying the present time.
3. Your heater will now automatically start up the pre-set time.
3. Your heater will now automatically start up the pre-set time.
4. If you wish to start up the heater at the pre-set time again, repeat the same procedure 1.
mentioned above.
4. If you wish to start up the heater at the pre-set time again, repeat the same procedure 1.
mentioned above.
NOTE : The pre-set time will remain so long as the heater receives electrical power. In the
event of power failure or disconnection of heater for more than 10 minutes, timer
NOTE : The pre-set time will remain so long as the heater receives electrical power. In the
setting will be cancelled.
event of power failure or disconnection of heater for more than 10 minutes, timer
LC-32F (GB) 12.9.3 11:39 AM ページ 7 setting will be cancelled.
NOTE : If normal ignition was used to set the heater burning (i.e. the heater is burning but
the Timer Lamp on the Indicator panel is out), pressing the Timer key will
NOTE : If normal ignition was used to set the heater burning (i.e. the heater is burning but
extinguish the heater, and the heater will be put into the "Timer"mode.
the Timer Lamp on the Indicator panel is out), pressing the Timer key will
extinguish the heater, and the heater will be put into the "Timer"mode.
TEMPERATURE REGULATION
1. Use the Adjustment keys ( ▼ hour / ▲ min.) to adjust the
temperature.
2. Adjust the temperature using the key on the right ( ▲ min.) to set
the temperature to a higher setting and the key on the left
( ▼ hour ) to lower the temperature.
3. Until the room temperature has reached the set temperature, the heater will burn at either
high or medium burning mode. When the room temperature reaches or slightly exceeds
the set temperature, the heater will automatically shift to maintain the desired
temperature.
NOTE : The standard setting of the heater is 20°C. However, once the set temperature has
2
2
button and then the "Timer" key immediately after
button and then the "Timer" key immediately after
key and then the "Timer" key immediately after
3 4
3 4
6
6
8
1
1