Kero-Sun Laser Clean LC-34 Instruction Manual page 11

DO NOT : Restart your heater for at least ten minutes.
AUTOMATIC DEACTIVATION
This heater is fitted with a safety system that ensures that it swiches
off automatically after 65 hours continuous operation. The following
will then appear in the display:
heater on again by pressing the
SET ALTITUDE
1. If the heater is used at a height of 800 m to 1300 m, use the
altitude mode 1. Push the altitude button with thin rod like a
clip and plug into the outlet simultaneously. Then " 1
shown on the display.
2. If the heater is used at a height of 1300 m to 1900 m, use the
altitude mode 2. After setting the altitude mode 1, push the
altitude but ton with thin rod and plug into the outlet
simultaneouosly again. Then " 2
display.
3. Switch off the altitude mode by pressing the altitude button
and into the outlet simultaneously after setting altitude mode
2. Then " 0 " will be shown on the display and " " will be
disappeared.
NOTE: When the altitude mode 1 is set, the altitude mark " " is lit on the display.
When the altitude mode 2 is set, the altitude mark " " is blinking during operation.
NOTE: In the event of power failure or disconnection of heater, the altitude setting will
remain.
!
Do not use the heater at a height of over 1900 meters.
SWITCH THE VOLUME
This heater can be switched the buzzer sound volume. The initial setting is in High level.
1. Push the SAVE key and holding it down for more than 3 seconds, then the buzzer sound
volume is switched from High to Low.
2. Push the SAVE key and holding it down for more than 3 seconds again, then the buzzer
sound volume is switched from Low to High.
NOTE: The volume level is Low and High only, but the alarm by safety device sounds in
High level.
NOTE: When the heater has been unplugged or after a power failure, the volume will be the
initial setting High.
65
65 Hr
. If desired, you can switch the
key. button.
" will be shown on the
" will be
9
11