Emergency Message - Kero-Sun Laser Clean LC-34 Instruction Manual

EMERGENCY MESSAGE

In the event that heater should extinguish itself, without any action or your part, you should
look to the digital indicator for any of the following messages.
MESSAGE
(Digital Indicator)
E-0
F-0
E-1
F-1
E-2
E-23
E-5
E-6
E-7
E-8
E-81
E-9
65 Hr
--:--
(& blinking FUEL-indicator)
--:--
(& blinking VENT-indicator)
MESSAGE MEANING
Temperature within the heater too high.
Power interrupted. You can re-ignite the heater.
Thermostat is broken or disconnected. Contact your dealer.
Faulty burner thermistor. Contact your dealer.
Primary flame rod is malfunctioning and /or dirty.
Re-ignite the heater immediately after extiguishing. Wait for
approx. 30 sec. and re-ignite after inserting the plug again.
You have accidentaly activated your safety tip-over switch. You
should reset this device as described, press the "OFF" button
and restart your heater.
Burner flame has been extinguished during operation.
Check to see if air filter is clogged with dust. If so, clean air filter.
Room temperature above 32°C
Failure of blower motor.
Abnormal frequency. Insert the plug into the wall-socket again.
Contact your dealer.
Air filter dirty; or Fuel pump dirty.
The heater has been in operation continuously for a period of 65
hours and has turned itself off automatically. Switch the heater
back on.
Out of fuel. Refill removable fuel tank.
Too little ventilation. Ventilate better.
12