Datalogic PowerScan D8300 Reference Manual page 158

Enter Configuration
Ì$+;Î
SCANNER DATA HEADER/TERMINATOR
Scanner Data Header/Terminator creates an optional Header and Terminator data format
added to a barcode read from the device.
NOTE: Keyboard data format enable/disable (on previous page) must be used to enable the
Header and Terminator setup, so the two parameters should be combined to get the desired
result.
 no header
two character header

four character header

six character header

eight character header

After selecting one of the desired Header codes, read the character(s) from the HEX table.
Valid characters are in the range 00-FE. For Wedge and USB-KBD interfaces, it is also possible
to read the Special Key(s) on page 74.
Example :
Four character header
Read
For more details see par. 5.4.1 and par. 5.4.2. See also "Message Formatting" in par. 6.1 and
6.2.
16-KEY DK MODEL PARAMETERS
HEADER
41 + 42 + 43 + 44
+




Hex codes
=
Exit and Save Configuration
Ì$-?Î
one character header
three character header
five character header
seven character header
Header
ABCD
149