Datalogic PowerScan D8300 Reference Manual page 166

Enter Configuration
Ì$+;Î
Repeat Timeout allows the user to program an optional intercode delay (in msec.) between two
codes in a set of codes to be transmitted from scanner to host via Radio interface, when the
scanner is in quantity mode.
NOTE: Qty/Code Send Mode must be set to option 2 (code in CODE field is sent out for a
QTY number of times). See Qty/Code Send Mode on the previous page).
The number of codes depends on the unit inserted via keypad by the user, to cope with different
use cases. A minimum delay of 100 ms will be always present, the delay can be adjusted in
10ms increments.
Disable

 Read the above code.

Select the length of the delay you want to set by scanning two barcodes (01 – 99) from the
Hex Numeric table in the back of this manual.
Example : To program Repeat Timeout = 60ms
set Repeat Timeout
Read
16-KEY DK MODEL PARAMETERS
REPEAT TIMEOUT
+
set Repeat Timeout
Value
06 =
Exit and Save Configuration
Ì$-?Î
Time (ms)
60ms
157