Bolin Technology VCC-4KHDB-M-11142018 User Manual page 22

Note
You cannot set IR-RECEIVE to OFF when you operate the menu using the infrared remote controller. To set it to OFF,
use the appropriate VISCA controller.
DISPLAY INFO
When this item is set to ON, the message of the camera configuration appears for about 3 seconds on the
screen, after the camera is powered on or rebooted.
FACTORY RESET
You can select this item to set camera back to Factory Default setting by pressing HOME button to confirm the action.
All data of the camera that have been set will be deleted.
RELOAD PRESET 1:
When this item is set to ON, preset 1 is set to Home position. The camera goes to Home position when it is powered on
or reset.
AUTO FOCUS
Set speed of auto-focusing from Low to Normal.
VIDEO FORMAT:
You can change the video format by adjusting this item. Select the item, press "←" button to choose the video format you
want to set to, then press "→" (Pressing "→" button changes value on some product models) or HOME button to confirm
it. After you confirm your choice, press HOME button again to restore it. The camera will reboot by itself. The new video
format is activated.
You can cancel it by pressing the DATA SCREEN button.
The video formats that you can select from are: 2160p:25/29.97; 1080p:59.94/50; 1080i:59.94/50; 720p:59.94/50
You can select SDI video format. 1080p:59.94/50/29.94/25; 1080i:59.94/50; 720p:59.94/50.
Note
The camera video format can be changed by setting bottom DIP switch as well. For detail, see page 18.
22