Advertisement
DO NOT use the heater with a programmer, timer or any other device that switches the heater on automatically.
DO NOT touch the lamps, even when cold.
DO NOT use the heater without the wheels fitted and locked.
DO NOT allow children to touch or to operate the heater.
DO NOT locate the heater below an electrical socket outlet.
DO NOT use the heater without the grille fitted.
DO NOT use the heater out of doors. These heaters are designed for indoor use only.
DO NOT use this heater if it has been dropped.
DO NOT use if there are visible signs of damage to the heater.
DO NOT cover heater when in use, and do not obstruct the air inlet and outlet grilles.
DO NOT place heater too close to yourself or any object, allow the air to circulate freely.
DO NOT touch the outlet grille of the heater during and immediately after use as it will be hot.
Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in
its intended normal operating position and they have been given supervision or instruction concerning the use of the appliance in a safe
way and understand the hazards involved. Children aged from 3 years to less than 8 shall not plug in, regulate and clean the appliance or
perform user maintenance.
This appliance can be used by children aged from 8 years and above and persons with physical, sensory or mental capabilities or lack
of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
2. INTRODUCTION
Powder coated metal cabinet with two ruby halogen infrared elements and chemically polished refl ectors for maximum heat emission. Adjustable
thermostat control (15°C – 45°C). Soft-touch control panel with LED display. Programmable 7-day timer function. Equipped with a tilt cut-out
switch for added safety. Features easy-rolling castors (two locking). Suitable for a wide range of heating including restorative applications.
Supplied with cable and 3-pin plug.
3. SPECIFICATION
Model no ........................................................................ IR14
Power ................................................................. 1400/2800W
Supply .................................................................. 230V - 13A
4. ASSEMBLY
4.1.
Attach the wheel sub-assemblies to the base of the heater using the bolts provided. Ensure the lockable wheels are to the rear of the
heater.
4.2.
Attach the handle to the top of the heater using the bolts provided, ensuring the shaped spacers are fitted between the heater and the
handle as shown.
4.3.
Remove the front grille by unscrewing the retaining screws.
4.4.
Extract the lamps from the shipping carton.
WARNING! Never touch lamp glass directly with fingers, only touch the ceramic ends or use a soft cloth, otherwise elements could be
damaged.
4.5.
Carefully insert each lamp into the two push-in side fittings with a gentle pressure.
4.6.
Check the lamps are properly located.
4.7.
Reassemble front grille.
5. OPERATION
WARNING! DO NOT touch the top of the heater when in use as it becomes hot.
WARNING! Always allow elements to cool before moving the units. Use only on a smooth even surface. Failure to do so will cause premature
wear to the lamps and reduce their working life.
5.1.
The heater has a built in tilt switch safety mechanism that switches off the unit if it is tilted beyond 25° either forwards or backwards.
This prevents fire in the event of the unit being knocked over. If the unit does not turn on again when returned to the vertical, tip it
approximately 25° in the opposite direction until you hear the internal switch operate. As the heater switches on return it to the vertical
position.
WARNING! This heater is not equipped with a device to control the room temperature. DO NOT use this heater in small rooms when they
are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
5.2.
Place the heater on a level floor in the area you require to heat.
5.3.
Allow a minimum of 2m between the heater and adjacent objects.
5.4.
POWER ON/OFF
5.4.1.
Connect to mains supply turn on red rocker switch.
5.4.2.
Heater is in standby screen shows 'OF'.
5.4.3.
Press
to start heater. Screen shows: week, time, ambient
temperature and power indication.
5.4.4.
Press
again heater turns off , returns to standby screen shows 'OF'.
5.5.
SETTING TEMPERATURE
5.5.1.
Default temperature at power on is 30°C.
5.5.2.
Press
or
5.5.3.
After 5 seconds screen defaults to ambient temperature.
© Jack Sealey Limited
to set temperature. One press = 1°C. Screen shows temperature only. Range is 15 to 45°C.
Original Language Version
IR14 Issue:2(5.12) 24/08/21
Advertisement
