Installation; Unpacking And Inspection - Bredel APEX 10 Original Instructions Manual

INSTALLATION

3 INSTALLATION
3.1

Unpacking and Inspection

Follow the unpacking instructions on the packaging.
Check that your delivery is correct and does not have
transport damage. Report any damage immediately to
your Bredel representative.
This chapter describes the installation of the bare shaft
set. Refer to the manual of the pumphead for
installation and setup of the complete pump and the
pipework.
3.2 Installation
CAUTION
The drive or gearbox and the pump must
be aligned within the misalignment limits of
the flexible coupling.
Carry out the alignment of the drive or
gearbox and the pump at the pump's final
operating position. If the support set has to
be bolted to the floor this must be done
first.
A movement of the complete pump can
disturb the alignment due to elasticity of
the construction.
If the bare shaft set is delivered as part of a
complete pump, including pumphead and
drive, a realignment must be done at the
pump's final operating position.
6