Mounting The Support Set And Bare Shaft Kit - Bredel APEX 10 Original Instructions Manual

3.2.1

Mounting the support set and Bare Shaft Kit

For mounting the kit to the pumphead, the pump must
not be part of a process line and must be free of
lubricant.
1. Place the bare shaft kit (A) on a flat surface with
the key end upward.
Press coupling half (B) onto the shaft end until
shaft end face (C) and coupling surface (D) are
at equal level.
Slightly fasten screw (E).
Prevent unnecessary axial load on the bearing.
Alternative method of pressing the coupling half
onto the shaft end is using a threaded rod
screwed into the threaded hole in the shaft end,
a disc with hole and a nut. Turning the nut will
drive the coupling half onto the shaft.
This way the coupling half can be mounted after
the placement of the bare shaft kit on the
pumphead.
2. Use a hoist to place the pumphead with the
cover side on blocks.
INSTALLATION
D
E
C
B
A
7