Mounting The Drive - Bredel APEX 10 Original Instructions Manual

MAINTENANCE
4.7

Mounting the Drive

1. Use a hoist to place the drive on the support
set.
2. Make sure the spider (B) is placed in one of the
coupling halves (A).
3. Slide the drive toward the pumphead.
Make sure the coupling halves (A) and the
spider mesh correctly.
4. Place fasteners (B) to fix the drive on the
support set. Do not tighten them yet.
5. Use two alignment jigs (A) to check the
alignment of the coupling halves in the
horizontal plane. Looking from above both
coupling halves (C) must touch the edge of both
jigs.
If necessary move the drive (B) over the plate to
accomplish this.
This will eliminate horizontal misalignment of
the coupling halves.
18
A
B
A
C A C
A B
A
B