Bredel APEX 10 Original Instructions Manual page 13

INSTALLATION
3. Place coupling half (A) on the output shaft of the
drive and slightly fasten screw (B).
Make sure the shaft end has been shifted far
enough into the coupling half but will not
penetrate into the coupling spider (C).
4. Use a hoist to place the drive on the support
set.
5. Make sure spider is placed in one of the
coupling halves.
6. Slide the drive toward the pumphead.
Make sure that the coupling halves (A) and the
spider mesh correctly.
7. Use two alignment jigs (D) to check the
alignment of the coupling halves in the vertical
plane. Looking from aside both coupling halves
(C) must touch the horizontal edge of the upper
jig.
If necessary loosen the fasteners (A), readjust
the plate (B) and fasten the fasteners (A) to
accomplish this. Use a hoist to lift the drive.
Axial, radial and angular displacement of the
coupling halves must be minimised. See section
6.4.
8. Each side plate of the support set has 2 sets of
3 holes (A). Determine if the upper, the middle
or the lower hole is most suitable to be drilled
through into the side wall of plate (B).
Use a drill of 8mm to drill this hole through both
plates.
10
C
A
B
A
C D
B A
A
B
C