Mounting The Bare Shaft Kit Onto The Pump - Bredel APEX 10 Original Instructions Manual

7. Place key (B) onto the shaft.
8. Place retaining ring (A) into the hub.
9. Mount a coupling half on the shaft end. See
section 3.2.1 step 1.
4.6

Mounting the Bare Shaft Kit onto the Pump

For this procedure the pumphead should still be placed
on blocks with the support set resting on the
pumphead´s rear side. One coupling half is still
mounted on the drive shaft end.
If necessary apply a new spider for the flexible coupling.
1. Place the bare shaft kit (A) with the 3-teeth
coupling end into the pump and assure that the
teeth correctly mesh with the holes in the rotor
inside the pump.
2. Place washers and nuts (B).
3. Tighten the nuts in at least two crosswise
cycles. In the last cycle tighten them with the
correct torque. See section 6.3.
4. Use a hoist to turn the pumphead with support
set to horizontal position.
5. Fill the pumphead with lubricant. Refer to the
manual of the pump.
6. Connect the suction and discharge lines and
open any shut-off valves in these lines. Refer to
the manual of the pump.
MAINTENANCE
A
A
B
1 1 4 4
3 3
B
2 2
17