MAINTENANCE
2.
Use a suitable tool (A) to press seal (B) into the
hub until it hits the collar. Keep the closed side
of the seal upward.
3.
Put an excessive amount of grease on the lip of
the seal.
4.
Clean the contact surfaces (A) for bearing and
seal on the shaft (B). Put some grease on these
surfaces.
5.
Place shaft (C) on a flat surface with the key
end upward. Press bearing (B) on the shaft with
a suitable tool (A) until it touches the rim.
6.
Place the hub (C), with the bearing side upward,
on a flat surface with a hole.
Place shaft (D), with the key end pointing down,
into the hub (C).
Press bearing (B), with a suitable tool (A), into
the hub until it touches the bearing rim.
16
A
A
A
B
C
A
B
C
D
B
B