3.2.2
Mounting and aligning the Drive
Use a hoist to lift the drive.
Mounting and aligning the drive must be
done on the pump's final operation
position. Moving the complete pump
assembly after alignment will require re-
alignment at the pump's final operation
position.
1.
Determine the correct height (H) of the centre of
the bare shaft according to the surface on which
the drive will be mounted. The bare shaft height
must correspond with the height of the output
shaft centre of the drive that will be mounted.
2.
To correct the height loosen the six sets of
fasteners (A).
Move the plate (B) up or down to the correct
position and slightly tighten the fasteners (A).
Check the height and repeat this step if
necessary.
If the height is correct, tighten the fasteners (A)
with the correct torque. See section 6.3.
INSTALLATION
H
B
A
9