Alternative Installation Methods; Completing The Installation - STIEBEL ELTRON DHF 13 C-AU Operating And Installation Manual

INSTALLATION
Installation
Fitting the sealing elements for the appliance cover
1
1 Openings
2 Cover guides
3 Lower fixing screw
Material losses
!
If you cut open the wrong knock-out in the appliance
cover by mistake, you must use a new appliance cover.
f Secure the back panel with an additional screw at the
bottom.
f Secure the connecting pipes of the tap/valve to the appliance.
f Cleanly cut out the openings in the appliance cover. If neces-
sary, use a file.
f Click the cover guides into place in the openings.

10.2 Alternative installation methods

10.2.1 Water installation on unfinished walls
f Seal and screw in the twin connectors (not included in stand-
ard delivery).
2
1
3
3
1 Tee for cold water
2 Tee for domestic hot water
3 Cap
f Fit the water connections.
www.stiebel-eltron.com
f Fit the strainer and the plastic profile washer in the tee for
the cold water inlet.
Damage to the appliance and environmental pollution
!
3
The strainer must be fitted for the appliance to function.
2
f When replacing the appliance, check that the strain-
er is present.
f Screw the connection pipes from the appliance to the tee.
10.2.2 Power cable for finished walls
Material losses
!
If you cut open the wrong knock-out in the appliance
cover by mistake, you must use a new appliance cover.
f Cleanly cut or break out the required opening in the appli-
ance cover (for positions, see chapter "Specification / Dimen-
sions and connections"). If necessary, use a file.
f Route the power cable through the cable grommet and con-
nect it to the mains terminal.

10.3 Completing the installation

f Open the shut-off valve in the cold water inlet line.
DHF C-AU| 9