Related Manuals for STIEBEL ELTRON DHF 13 C-AU
Summary of Contents for STIEBEL ELTRON DHF 13 C-AU
- Page 1 OPERATING AND INSTALLATION Hydraulically controlled compact instantaneous water heater » DHF 13 C-AU » DHF 15 C-AU...
-
Page 2: Table Of Contents
CONTENTS | SPECIAL INFORMATION SPECIAL INFORMATION SPECIAL INFORMATION OPERATION General information �����������������������������������������3 - The appliance may be used by children aged 3 Safety instructions ����������������������������������������������� 3 and older and persons with reduced physical, Other symbols in this documentation ����������������������� 3 Units of measurement ������������������������������������������ 3 sensory or mental capabilities or a lack of ex- perience and know-how, provided that they Safety ����������������������������������������������������������4... -
Page 3: General Information
OPERATION General information OPERATION Other symbols in this documentation Note General information is identified by the adjacent symbol. f Read these texts carefully. General information The chapters "Special information" and "Operation" are intended Symbol Meaning for both users and qualified contractors. Material losses The chapter "Installation"... -
Page 4: Safety
OPERATION Safety Safety Appliance description The hydraulically controlled instantaneous water heater heats the Intended use water as it flows through the appliance. The heating output starts automatically as soon as a tap is opened and the starting flow The appliance is intended for domestic use. It can be used safely rate is exceeded (see chapter "Specification / Data table"). -
Page 5: Cleaning, Care And Maintenance
OPERATION Cleaning, care and maintenance Troubleshooting Recommended settings when using a thermostatic valve f Set the output selector to full power. Problem Cause Remedy Twin lever tap The appliance will not There is no power. Check the fuses/MCBs in start despite the DHW your fuse box/distribu- Output stage Application range... -
Page 6: Installation
INSTALLATION Safety INSTALLATION Preparation Installation location Safety Material losses Install the appliance in a room free from the risk of frost. Only a qualified contractor should carry out installation, commis- sioning, maintenance and repair of the appliance. f Always install the appliance vertically and near the draw-off point. -
Page 7: Standard Installation
INSTALLATION Installation Taps/valves Preparing the power cable Use appropriate pressure taps. Open vented taps are not per- missible. ≥ 30 Thermostatic pressure valves must be suitable for hydraulically controlled instantaneous water heaters. Permissible water line materials - Cold water inlet pipe: Making the water connection Pipes made from galvanised steel, stainless steel, copper or plastic... - Page 8 INSTALLATION Installation f Fit the cold water inlet pipe and the DHW outlet pipe from Fitting the cable grommet the pipework with flat gaskets to the extensions from the appliance. Fitting wall mounting bracket and appliance 1 Cable grommet f Fit the cable grommet. 1 Wall mounting bracket 2 Threaded stud Making the electrical connection...
- Page 9 DHF 13 C-AU, DHF 15 C-AU Installation template...
- Page 10 383 mm...
- Page 11 398 mm D0000043269...
-
Page 13: Alternative Installation Methods
INSTALLATION Installation Fitting the sealing elements for the appliance cover f Fit the strainer and the plastic profile washer in the tee for the cold water inlet. Damage to the appliance and environmental pollution The strainer must be fitted for the appliance to function. f When replacing the appliance, check that the strain- er is present. -
Page 14: Commissioning
INSTALLATION Commissioning 11. Commissioning Appliance handover f Explain the appliance function to users and familiarise them with how it works. WARNING Electrocution f Make the user aware of potential dangers, especially the risk Commissioning must only be carried out by a qualified of scalding. -
Page 15: Troubleshooting
INSTALLATION Troubleshooting 13. Troubleshooting Fault Cause Remedy No hot water. The fuse/MCB in the fuse box has blown/responded. Check the fuse/MCB in your fuse box/distribution board. The heating system is faulty. Replace the tubular heater heating system. The appliance does not start. The mains water pressure is too low. -
Page 16: Specification
INSTALLATION Specification 15. Specification 15.2 Wiring diagram 3/PE ~ 400 V 15.1 Dimensions and connections ≤12 3’ 1’ 2’ I > 15.3 DHW output The DHW output is subject to the mains voltage, the appliance's b02 Entry electrical cables I connected load and the cold water inlet temperature. -
Page 17: Data Table
This will not affect warranties issued by any importers. Environment and recycling 15.5 Data table DHF 13 C-AU DHF 15 C-AU We would ask you to help protect the environment. After use, 222214... - Page 18 Contact person: Customer Service Representative The Stiebel Eltron warranty for the unit is in addition to any rights E-mail: service@stiebel-eltron.com.au and remedies you may have under the Australian Consumer Law.
- Page 19 NOTES www.stiebel-eltron.com DHF C-AU|...
- Page 20 Deutschland Verkauf Tel. 05531 702-110 | Fax 05531 702-95108 | info-center@stiebel-eltron.de STIEBEL ELTRON GmbH & Co. KG Kundendienst Tel. 05531 702-111 | Fax 05531 702-95890 | kundendienst@stiebel-eltron.de Dr.-Stiebel-Straße 33 | 37603 Holzminden Ersatzteilverkauf Tel. 05531 702-120 | Fax 05531 702-95335 | ersatzteile@stiebel-eltron.de Tel.
Need help?
Do you have a question about the DHF 13 C-AU and is the answer not in the manual?
Questions and answers