MacDon FlexDraper FD2 Series Installation Instructions Manual page 4

Summary of Changes
At MacDon, we're continuously making improvements, and occasionally these improvements affect product
documentation. The following list provides an account of major changes from the previous version of this document.
Section
Throughout
Introduction, page i
3.1 Removing Reel Drive
Cover, page 7
3.2 Loosening Reel Drive
Chain, page 9
3.3 Installing Reel Driven
Optional Dual Sprocket,
page 10
3.4 Tightening Reel Drive
Chain, page 12
3.5 Installing Reel Drive
Cover, page 13
—
215318
Summary of Change
Remove reference to unreleased products.
Add a chart and image to clarify that an additional top sprocket is
required, and the specific model of the top sprocket depends on the
combine's hydraulic relief pressure.
Remove "if necessary" from step that removes the bottom reel drive
cover.
Profiled redundant steps to shut off engine, lower header, etc. Steps
are not required for every topic in a kit instruction.
• Profiled redundant steps to shut off engine, lower header, etc.
Steps are not required for every topic in a kit instruction.
• Add note about installing chain on outer top sprocket.
• Added reference to sprocket tightening steps if loosening and
adjustment is necessary.
Profiled redundant steps to shut off engine, lower header, etc. Steps
are not required for every topic in a kit instruction.
Profiled redundant steps to shut off engine, lower header, etc. Steps
are not required for every topic in a kit instruction.
Remove open/close endshield topics. Add refer to header operator's
manual throughout instruction.
ii
Internal Use Only
Technical
Publications
Product Support
Technical
Publications
Technical
Publications
Technical
Publications
Technical
Publications
Technical
Publications
Technical
Publications
Revision B