Table of Contents
Advertisement
2.3 Installing the System into a Rack
There are a variety of rack units on the market, which may require a slightly different assembly
procedure. This rail set fits a rack between 25.6" and 33" deep.
The following is a basic guideline for installing the system into a rack with the rack mounting
hardware provided. You should also refer to the installation instructions that came with the
specific rack you are using.
If you are installing into a two-post "telco" rack, skip to that section later in this chapter.
Identifying the Rails
The chassis comes with two sets of rack rails, one set for the right side of the chassis and
one for the left. Each set consists of an inner rail that is
outer rail that attaches to the rack.
Figure 2-1. Identifying the Sections of the Rack Rails
Slide rail mounted equipment is not to be used as a shelf or a work space.
Warning: do not pick up the server with the front handles. They are designed to pull
the system from a rack only.
Chapter 2: Server Installation
pre-attached
Inner Rail--
pre-attached to the chassis
Front and Rear Brackets--
19
to the chassis, and an
Outer Rails--
slide together
attach to the rack
Advertisement
Table of Contents
