Cablescan 64 Instruction Manual page 24

Page 16 Model 64/64x2 Instruction Manual
Save Internal
This function is used to copy a wire list program from the working memory to one of the storage
locations in the Internal Memory.
Save Cartridge
This function is used to copy a wire list program from the working memory to one of the storage
locations in the Program Cartridge.
Delete Internal
This function is used to erase a wire list program from one of the storage locations in the Internal
Memory. The program to be erased is identified by its signature code.
Delete Cartridge
This function is used to erase a wire list program from the Program Cartridge. The program to
be erased is identified by its signature code.
Clear Memory
This function is used to clear the working memory, which is the area reserved for the program
currently being used for test/assembly functions. When used, Clear Memory erases the program
completely, including the User Labels, rather than copying it as is the case with Save Program.
(For saving a program rather than erasing it, use "Saving a Program" procedure, which is
discussed later.) Please note that Clear Memory must be used prior to Learn Known Good if
User Labels are present and are not to be part of the learned program.
Set Baud Rate
This function is used to select the baud rate of either 1200 for printing, or 9600 for connection to
a PC.
Print Wire List
This function prints the wire list program currently in the working memory (loaded program). If
User Labels are not programmed, the wire list contains the tester point numbers for the two
terminating locations (FROM/TO points) for each wire or circuit in the assembly. If User Labels
are programmed, the labels will be printed in lieu of the tester point numbers. The wire list is
printed in the order in which the circuits were learned or downloaded.
Print User List
This function prints the User Labels assigned to tester points for the wire list loaded in the
working memory. Each test point may have up to 6 characters assigned. Generally, User Labels
are used to relate tester points to corresponding connector/pin numbers on the harness.