Cablescan 64 Instruction Manual page 21

Model 64/64x2 Instruction Manual Page 13
Test
This is a single-scan test; when TEST is selected, one complete scan is performed on the circuit
under test, comparing it with the wire list program in memory. If the test is successful, the
display shows "Passed XXXX/YYYY," and the tone sounds. If an error is encountered, the
points in error are displayed, along with an indication of whether the error is an OPEN or
SHORT.
Reset
When RESET is selected, the Tester assumes a "wait" state, and it remains in that state until
another mode is selected. RESET also can be used to terminate a mode in operation.