Table of Contents
Advertisement
6.
Twist Emergency Stop button clockwise until
it springs out. This resets switch so spindle
can turn.
7.
Press blue RESET button.
8.
Verify machine is operating correctly by
turning spindle direction switch to "FWD"
position, then slowly turn speed control knob
clockwise.
— When operating correctly, machine runs
smoothly with little or no vibration or rub-
bing noises.
— Investigate and correct strange or unusu-
al noises or vibrations before operat-
ing machine further. Always disconnect
machine from power when investigating or
correcting potential problems.
9.
Turn speed control knob all the way left.
10. Turn spindle direction switch to "REV" posi-
tion, and slowly turn speed control knob
clockwise.
— When operating correctly, machine runs
smoothly with little or no vibration or rub-
bing noises.
11. Move spindle direction switch to neutral posi-
tion, and push in Emergency Stop button.
12. Without resetting Emergency Stop button,
turn spindle direction switch to "FWD" and
"REV" positions. Machine should not start at
either position.
— If machine does not start, Emergency Stop
button safety feature is working correctly.
Test run is complete.
— If machine does start (with Emergency
Stop button pushed in), immediately dis-
connect power to machine. Emergency
Stop button safety feature is not working
correctly. This safety feature must work
properly before proceeding with regular
operations. Call Tech Support for help.
Model G0799 G0800 (Mfd. Since 11/17)
Anchoring to Floor
Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware .................
Anchoring machinery to the floor prevents tipping
or shifting and reduces vibration that may occur
during operation, resulting in a machine that runs
slightly quieter and feels more solid.
If the machine will be installed in a commercial or
workplace setting, or if it is permanently connect-
ed (hardwired) to the power supply, local codes
may require that it be anchored to the floor.
If not required by any local codes, fastening the
machine to the floor is an optional step. If you
choose not to do this with your machine, we rec-
ommend placing it on machine mounts, as these
provide an easy method for leveling and they have
vibration-absorbing pads.
Anchoring to Concrete Floors
Lag shield anchors with lag screws (see below)
are a popular way to anchor machinery to a con-
crete floor, because the anchors sit flush with the
floor surface, making it easy to unbolt and move
the machine later, if needed. However, anytime
local codes apply, you MUST follow the anchoring
methodology specified by the code.
Machine Base
Concrete
Figure 29. Popular method for anchoring
machinery to a concrete floor.
⁄
"
5
8
Lag Screw
Flat Washer
Lag Shield Anchor
Drilled Hole
-27-
Advertisement
Table of Contents
