Go1 Basic Operation With Label Controller - Unitree Go1 Manual

GO1 Basic Operation with Label controller

Here is an introduction to the use of the label controller
1) power on the robot, then waiting 1min it will stand up by itself and the light band on the robot's head
will flash. This means that you can control the robot dog through the remote control or label
2)POW -> Short press once, then long press for 2 seconds to turn on and off the remote control
Remarks:
The label should be turned on in a fixed position before powering on.As shown below
Buckle the remote control to the waist belt on the right side of the human body. The human body is
standing on the left side of the robot, with the torso facing the same as the robot. Short press and long
press the POW button that automatically follows the remote control, when the indicator lights up steadily,
13