Loading The Machine - Fayat Dynapac DR7X Operating Instruction

Loading/transporting the machine – Loading the machine

7.1 Loading the machine

Fig. 40
58
Loads may only be attached and hoisted by an expert/qualified
person.
Do not use lifting points that are damaged or impaired in any other
way.
Only use lifting and lashing tackle with sufficient load bearing
capacity for the weight to be loaded. Minimum load bearing
capacity of lifting tackle: see operating weight
nical data" on page 11.
Always use appropriate lifting and lashing tackle at the lifting and
lifting points.
Use lifting tackle only in the specified loading direction.
Lifting tackle must not be damaged by machine parts.
When lifting the machine, make sure the load does not move in an
uncontrolled way. If necessary, hold the load steady with guide
ropes.
Protective equipment:
1. Park the machine safely
in secured condition" on page 53.
2. Make sure that no fuel will be spilled from the tank during
transport:
Close the fuel tank tightly.
n
n Consider the filling quantity in the tank in case of temper-
ature fluctuations (pressure relief valve in tank lid); drain
off fuel if necessary.
3. Attach the lifting tackle to the dedicated lifting eye.
4.
Lift the machine carefully and set down again at the intended
B-541-0018
location.
DR7X
Protective gloves
n
n Safety shoes
Ä Chapter 6.4 „Parking the machine
DANGER!
Danger to life caused by suspended
loads!
– Do not step or stand under suspended
loads.
Ä Chapter 2 „Tech-