Advertisement
Step 15
You will need
12 x Large
Phillips head
Cam Nuts (H2)
screwdriver
This is how a cam nut works........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Insert large cam nuts (H2) into the left and right drawer sides (P10 & P11), rotate the large cam
nuts (H2) so the arrow is pointing towards the incoming cam bolt (H1).
To secure the left and right drawer sides (P10 & P11) to the drawer front (P9), use the phillips head
screwdriver to tighten the large cam nuts (H2).
Repeat steps for the other two drawers.
Step 16
You will need
3 x Small
Phillips head
Cam Nuts (H6)
screwdriver
This is how a cam nut works........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Insert small cam nuts (H6) into the drawer support rail (P12), rotate the small cam nuts (H6)
so the arrow is pointing towards the incoming cam bolt (H5).
To secure the drawer support rail (P12) to the drawer front (P9), use the phillips head
screwdriver to tighten the small cam nuts (H6).
Repeat steps for the other two drawers.
www.fantasticfurniture.com.au
x 3
x 3
PAGE 12
Advertisement
