Advertisement
Step 11
You will need:
7 x Cam
Nuts
(H2)
Phillips head
screwdriver
This is how a cam nut works........
The head of the cam
bolt goes into the open
mouth of the cam nut.
You then turn the cam
nut so it tightens over
the bolt.
Attach Right Side (P3) to all the Rails which already attached to Left Side (P2), insert
Cam Nut (H2) into Rail(P9, P10), rotate the Cam Nuts so the arrow point towards the
incoming cam bolt, turn clockwise to lock.
Step 12
Turn the unit upright carefully, slip Back Panel (P11) into the grooves on the side
panels, make sure the infirmative label on position as the drawing shown.
www.fantasticfurniture.com.au
informative label
nearby top
(P11)
(P3)
x 7
PAGE 10
Advertisement
