Panasonic WH-MXC09J3E8 Service Manual page 60

For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Connect the remote
control wiring
This section is for authorized and licensed electrician only. Work behind the Cabinet
Front Plate ⑯ secured by screws must only be carried out under supervision of
qualified contractor, installation engineer or service person.
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
U P
Hole for
screw
Claw (2 places)
Screw
(field supply)
Remote controller
terminal board
Top case
(Back side)
Bottom case
(Back side)
Make sure the wiring
connection is in the correct
direction.
WARNING
60
Remove the coating.
Approx. 6 mm