Installing The Processor And Heatsink - TYAN S7120 Manual

2.6 Installing the Processor and Heatsink

The types of processors supported by the S7120 are listed in the 1.2 Hardware
Specifications section on page 4. Check our website at
the latest list of validated Intel
NOTE: MiTAC is not liable for damage as a result of operating an
unsupported configuration.
Processor Installation (Dual Socket LGA4189 for Intel Icelake CPU)
Follow the steps below to install the processors and heat sinks.
Please note that the illustrations are based on LGA4189 socket which may not look
exactly like the motherboard you purchased. Therefore, the illustrations should be
held for your reference only.
NOTE: Please save and replace the flip CPU protection cap when returning for
service.
1. Align the triangle edge of the carrier with the notch on the edge of the
heatsink. Then install the carrier on the bottom of the heatsink and make sure
the latches are snapped under the edge of the heatsink.
2. Carefully flip the heatsink. Then install the carrier assembly on the bottom of
the heatsink and make sure the gold arrow is located in the correct direction.
®
processors for this specific motherboard.
25
http://www.tyan.com
http://www.tyan.com for