Table of Contents
Advertisement
2.8
PREPARATION FOR MOUNTING THE FLUE TERMINAL
a)
Position the flue terminal over the inner and outer flue pipes as shown
on fig. 12 below, checking that the outer pipe has the seam flange at
the bottom and the inner pipe has the seam flange at the top.
Fig. 12
b)
Having positioned the terminal so that it is square to the wall, mark the
position of the mounting bracket holes on the outer wall, using the
terminal as a template. Remove the flue terminal and drill the 2 off
holes 6mm diameter into the wall. Insert the raw plugs Replace the
terminal onto the flue pipe and secure using the No.12 x 40mm screws
provided. See fig. 13
Fig. 13
NOTE :
In England & Wales, the building regulations require that a terminal
guard should be fitted if the terminal could come into contact with people
near the building or be subject to damage. BFM Europe also recommend the
fitting of a flue terminal guard where regulations do not demand that it be
fitted. A suitable flue terminal guard is supplied with the appliance.
15
Advertisement
Table of Contents
