aventon Pace 350 User Manual page 4

The replacement of original components or installation of third-party accessories or accessories
not from Aventon explicitly recommended for your bike model is at your own risk. Using
aftermarket accessories or components that have not been tested by Aventon for safety and
compatibility may void your warranty, create an unsafe riding condition, damage to property or
your bike by Aventon, or result in serious injury or death.
Safety Check Before Each Ride
Always check the condition of your bike before you ride in addition to having regular maintenance
performed. If you are unsure of how to conduct a complete check of the condition of your bike before every
ride, you should consult a certified, reputable bike mechanic for assistance.
Electrical System (Applicable to Pace 500, Pace 350, Sinch, Level, Soltera,
Aventure)
The electrical system powers several components on your ebike that control di erent operating conditions
and user preferences. It is critical that you familiarize yourself with all aspects of your ebike s electrical
system and check to see if it is working correctly before every ride. The front and rear brake levers contain
safety power cuto switches, which disable the hub motor s assistance when applied, and both levers
should be checked for correct operation. The throttle should provide smooth acceleration when gradually
applied. If the throttle, brake lever cuto switches, pedal assistance , or lighting are functioning abnormally,
intermittently, or not working, please discontinue the use of your ebike immediately and contact the
Aventon Support team for assistance.
Brakes
Ensure that the brakes and their system components are free from damage, properly secured and working
correctly. When fully squeezed, both front and rear brake levers should not be touching the handlebar. Take
your bike to a certified, reputable bike mechanic to have the brakes repaired if you find a problem.
Tires and Wheels
Your wheels should always spin straight and must be repaired or replaced if they wobble side to side or up
and down when spinning. If your wheels become untrue or spokes loosen, which can happen with normal
use, we recommend that a certified, reputable bike mechanic performs all wheel tuning and truing
operations on your bike from Aventon. DO NOT attempt to true wheels or tighten spokes unless you have
adequate knowledge, tools, and experience. Ensure the tires and inner tubes are in good working condition
without any visual damage and have the correct amount of air pressure. Always replace tires and inner
tubes with punctures, cuts, or damage before you ride. Tires without the correct amount of air pressure can
reduce performance, increase tire and component wear, and make riding your bike unsafe.
Accessories, Straps, and Hardware
Ensure all hardware is secured and all approved accessories are properly attached per the specific
component manufacturer s instructions. It is good practice to look over all hardware, straps, and accesso-
ries before each ride and if you do discover something wrong or something that you are not sure about,
have it checked by a certified, reputable bike mechanic.
Handlebar, Grips, and Seat Adjustments
Ensure the handlebar and handlebar stem are properly aligned, fitted to the user, and secured to their
recommend torque values. Handlebar grips should not move easily on the handlebar end. Loose, worn,
or damaged handlebar grips should be replaced before you ride . The seat and seatpost should be properly
aligned, fitted to the user, and the seatpost quick release should be properly tightened, fully closed, and
wsecured before riding.
'
'
'
03