aventon Pace 350 User Manual page 19

WHEN INSTALLING THE BATTERY ONTO THE BIKE
Ensure the battery is turned o .
DO NOT force the battery into the tray; slowly align and gently push the battery down into the tray.
Make sure there is no space between battery and tray, confirm battery has been fully secured on the tray.
Ensure the battery has been properly secured to the bike before each use by carefully pulling outwards
on the battery with both hands once locked.
CHARGER SAFETY INFORMATION
The charger should only be used indoors in a cool, dry, ventilated area, on a flat, stable, hard surface.
Avoid charger contact with liquids, dirt, debris, or metal objects. DO NOT cover the charger while in use.
Store and use the charger in a safe place away from children.
Fully charging the battery before each use to can help extend the life of the battery and reduces the
chance of over-discharging.
DO NOT charge the battery with any chargers other than the one originally supplied by Aventon Bikes
or a charger designed for use with your specific bike purchased directly from Aventon Bikes.
The charger works on 110/240 V 50/60 Hz standard home AC power outlets and automatically
detects and accounts for incoming voltage. DO NOT open the charger or modify voltage input.
DO NOT yank or pull on the cables of the charger . When unplugging carefully remove both the AC and DC
cables by pulling on the plastic plugs directly, and not on the cables.
The charger is expected to get relatively warmer as it charges. If the charger gets too hot to touch, you
notice a strange smell, or any other indicator of overheating, discontinue using the charger and
contact Aventon Support.
Charge the battery only with the charger originally supplied with the bike from Aventon Bikes,
or a charger purchased directly from Aventon Bikes, designed for use with your specific bike
serial number, as approved by Aventon Bikes. Never use an aftermarket charger, which can
result in damage, serious injury, or death.
Please take special care in charging your bike from Aventon Bikes in accordance with the
procedures and safety information detailed in this manual. Failure to follow proper charging
procedures can result in damage to your bike, the charger, or personal property, and/or cause
serious injury or death.
LONG-TERM BATTERY STORAGE
If storing your bike from Aventon Bikes for longer than two weeks at a time, follow the instructions below
to maintain the health and longevity of your battery.
Charge (or discharge) the battery to approximately 75% charged.
DO NOT leave the battery attached to the bike frame. Remove it from the bike during long-term storage.
Store the battery in a dry, climate controlled, indoor location in between 50˚F - 70˚ F (10˚C -25˚C). Check
the battery every month, and if necessary, use the Aventon Bike Charger to charge the battery to 75%.
Please follow the above instructions for storing your bike and battery from Aventon Bikes.
Failure to follow proper battery storage procedures can result in a non-functional battery.
Replacement will not be convered under warranty.
If the battery is physically damaged, non-functional, performing abnormally, or was dropped
or involved in a crash, with or without obvious signs of damage, please discontinue use and
charging and contact Aventon Bikes immediately.
17