aventon Pace 350 User Manual page 15

Step 13: Remove motor protector and put on the motor protection guard on both sides of back wheel.
Note: Part of plastic motor protector will likely break and be left in between the frame and the gears, use a pair of
pliers to carefully remove it.
Inflate the tires.
Step 14:
valve and pressure gauge to inflate each tire to the recommended pressure indicated on the tire sidewall, 30-50PSI (2.0-3.5
BAR).Do not overinflate or underinflate tires.
Set the desired seat height
Step 15:
down to a comfortable height, while ensuring the seatpost is inserted into the frame past the minimum insertion point.
If needed, use the thumb nut to add tension to the clamp so there is some resistance when the lever is in line with the
clamp bolt, but do not overtighten. Close the quick release lever to secure the seatpost and check that it cannot move.
See the Adjusting the Seat section of this manual for more details.
Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader
. Open the quick release lever by hinging it open fully. Adjust the seatpost up or
14