Advertisement
Step 9: Connect both the DS-700 module and your computer to the same sub network
or the same Ethernet Switch.
Step 10: Install the
your Host PC, and then run the Utility
to search for any DS-700 module
connected to the nework.
Download the VxComm Utility.
Step 11: Configure the correct network settings for the required DS-700 module.
Please refer to "Chapter 3-Configuring Network Settings" in the DS-700 Quick Start Guide. If the IP address
settings do not work correctly, please refer to
Download the Quick Start Guide.
Firmware Update via 7188XW.exe (Ver. 1.0/Aug. 2018)
VxComm Utility
on
note3 (Page
8).
Page: 6
Advertisement
