Turning The Machine On And Off - Canon PIXMA MX850 Series Quick Start Manual

Turning the Machine On and Off

Turn on the machine before printing.
Turning on the Machine
Note
If preparatory operations below are not complete, follow your setup sheet and/or the Network
Setup Guide to complete them.
The Print Head and ink tanks are set into place.
If you are using the machine connected to a computer, confirm also the following.
The machine is connected to your computer (or a compatible device).
The MP Drivers are installed.
1
Press the ON/OFF button to turn on the
machine.
The COPY button flashes and then remains lit
green.
Note
If the Alarm lamp lights up or flashes orange and an
error message is displayed on the LCD, see "An Error
Message Is Displayed on the LCD" on page 133.
2
If you are using the machine connected to a
computer, turn on your computer.
Turning off the Machine
1
To turn off the machine, press the ON/OFF
button.
When a selected mode button (e.g., COPY button)
stops flashing, the machine is turned off after all the
lamps on the Operation Panel go out. It takes a few
seconds or as long as around one minute.
Important
When you turn off the machine
Follow the procedure below to turn off the machine.
(1) Confirm that all the lamps on the Operation Panel
have gone out.
(2) Unplug the power cord from the wall outlet. If you
are using a power outlet strip, you can switch it off
instead.
When you press the ON/OFF button to turn off the
machine, the machine automatically puts a protective
cap on the Print Head to prevent the ink from drying. If
you remove the power cord or switch off the power
outlet strip before all the lamps on the Operation Panel
go out, this capping will not be done properly, causing
the Print Head to dry and clog.
Note
The power cannot be turned off while the machine is
sending or receiving a fax, or when there are unsent
faxes stored in the machine's memory.
14 Before Using the Machine