Error Reports - M2 AAD User Manual

9. Error reports

Error reports will be displayed on the device with the
be used for diving until the defect-failure is resolved. In order to discover the type of error, proceed as follows:
Quickly press the control button (2) on the control unit body (1). The display (2) will show the error number in the form of this example:
. Digit 2 specifies the type of error-defect.
Review of errors as per digit indication:
Calibration error to GROUND ZERO. The range of measured values is too large.
Solution: Switch the m
Cutter error. The cutter is incorrectly connected, used or damaged.
Solution: Check the cutter; potentially replace the cutter with a new one.
Low battery voltage.
Solution: Do not use the device. Contact the dealer, distributor or manufacturer.
Pressure sensor error, value out of the range.
Solution: Switch the m
facturer.
If the specified error reports are not successfully resolved or you are not sure how to solve
the problem, contact the dealer, distributor or manufacturer.
off and on, the calibration will be completed again.
2
off and on again. In case of repeated error, do not use the device and contact the dealer, distributor or manu-
2
. icon. If this icon appears on the display of the control unit, the m must not
2
32